GBA Logo horizontal Facebook LinkedIn Email Pinterest Twitter X Instagram YouTube Icon Navigation Search Icon Main Search Icon Video Play Icon Plus Icon Minus Icon Picture icon Hamburger Icon Close Icon Sorted

Community and Q&A

Hot water closed loop at 135 degrees F

user-5924747 | Posted in Mechanicals on

Hi , I have set up an anaerobic digester at my horse property , I have made a solar heater ( black hosepipe behind some upvc ) to heat it ,for best results I need to get the digester up to max temp 135 deg F , just had my first pump seize up , what of off the shelf pump can cope with that kind of temp , its running water around a closed loop of hosepipes

any and all suggestions welcome

GBA Prime

Join the leading community of building science experts

Become a GBA Prime member and get instant access to the latest developments in green building, research, and reports from the field.

Replies

  1. GBA Editor
    Martin Holladay | | #1

    David,
    Go to a plumbing supply distributor and buy a circulator designed for a hydronic heating system (a heating system with a boiler). You can also look online for a circulator designed for a solar thermal system.

    As long as you are circulating water (or a solution of water and antifreeze), not a slurry of horse manure, one of these circulators will work fine.

  2. charlie_sullivan | | #2

    Many hydronic circulators are cast iron. The reason they don't rust is that they are in a closed-loop system where the small amount of oxygen in the water gets quickly depleted, and there's no more oxygen available to corrode the iron. In order for that to work, the pipes can't allow oxygen to diffuse through them, so any plastic pipes have to be special versions that inhibit oxygen diffusion. That's why there are different grades of PEX tubing for hydronic systems vs. potable water.

    I think that means you have two choices:
    1) Pipe your whole system with metal or oxygen-barrier plastic, and use a cast iron circulator, or
    2) Get a more expensive bronze or stainless pump, and then you can use any tubing.

    Plastic pumps are cheaper and also don't rust, but finding one rated for 135 F might be hard.

    If you will be running the pump a lot, it would be worth getting one with an "ECM" motor which uses about 2X to 4X less electric power compared to traditional induction motor circulators.

Log in or create an account to post an answer.

Community

Recent Questions and Replies

  • |
  • |
  • |
  • |